Clip/Magazine Connector

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)



  • 3D Printed
  • Materials: PLA/ABS/U-PET
  • Made to order
  • Ships worldwide from Ephrata, Pennsylvania
SKU: NAG-ECC-5200 V1 Blk Category:


Product Details:
Go combat style with a double clip connector. This coupler allows you to combine two Nerf clips/magazines together combat style. Double the amount of ammo you can carry with this coupler.
The clip/magazine coupler can be used with Nerf N-Strike or Elite 6, 12, and 18 clips/magazines. Please make sure there is room for the coupler to fit without hitting any other parts on the gun. See dimensions below.
The clip containers are offset from the center of the coupler to allow for a clamping mechanism to lock the clips into the coupler. To install the clips simple slide them in the coupler opposing each other, then tighten two stainless steel set screws which are threaded into the body. The set screws push against a clamping plate to hold the clips in the coupler without damaging them. Warning: Do not overtighten the screw or you will damage the connector or prevent the clips from working properly.
3.75” (9.52cm) long, 2.43” (6.17cm) wide and 1.12” (2.84cm) in height.
You will need a 3/32” hex wrench to install this item.
Black (Ask about other colors for this product)
-(1) Clip Coupler
-(2) Stainless Steel Cap Screws

Additional information

Weight 34 g
Dimensions 3 x 2.43 x 1.12 in

Single Clip Holder, Double Clip Holder

1 review for Clip/Magazine Connector

  1. Rated 5 out of 5

    Mike (verified owner)

    High quality clip connector another great item from 3dprintedsolid, you can't go wrong with this, great fit, strong and durable…

Add a review

Your email address will not be published. Required fields are marked *