Here is a quick way to reload you Rival ball shooters. The dual mag holder fits on a Picatinny rail (Sold Separately) which can be attached to the standard Rival mounts. The mag holder is the slip-on style and is locked in place by two stainless steel set screws located in the body of the mount.
This mag holder will fit on any standard Picatinny mount. The mount slides on from the front or back of the rail and locks in place with two set screws. The mag holder will accept both long and short Rival mags.
The Rival Mag holder will hold both 7 and 12 round mags. The mags can be slid in from either side of the mag holder and are held in place by tension. There is a spring load cam mechanism which applies tension to the mag and holds it in place until it in needed.
2.55” (6.47cm) long, 3.25” (8.25cm) wide and in 2.12” (5.38cm) height.
You will need a 3/32”” hex wrench to install this item.
– (1) Rival Mag Holder (Cam Lock Design)
– (4) Stainless Steel Screws