The Standpunkt shoulder stock has an angled design meant for bridging the gap between the gun and shoulder. The Standpunkt attaches at two locations, the standard rear facing Nerf® stock attachment point and at very bottom of the weapon’s grip. This thumbhole stock design greatly improves the weapon usability in close quarter battles and gives you superior ability to control your aim. Once both mounts are locked down it provides a “Solid” bond between the stock and the weapon.
This stock is specifically designed for the Stryfe; it will not fit any other gun without significant modifications.
Place the two part grip attachment to the bottom of the nerf grip, by placing one half of the grip attachment on either side of the bottom sling attachment point. Tighten this up using a 7/64” hex key. DO NOT OVER TIGHTEN. Then align the shoulder stock with the Nerf® gun and push firmly to fit both connections. Using a Philips head screw driver tighten the single screw joining the lower sections of the stock and gun. Finally, tighten four set screws mounted on the bottom side of the upper stock section. DO NOT OVER TIGHTEN. Entire process should take no more than a few minutes.
12.75” (32.38cm) long (including Rest), 2.25” (5.71cm) wide and 7.2” (18.28cm) in height.
– 3/32” & 7/64” hex key.
– Philips head screwdriver.
– (1) Standpunkt Shoulder Stock
– (1) Grip Attachment and Stainless Steel hardware
*(Guns and other accessories show in pictures are shown as examples and are NOT included in the sale)